V2000-c Rfid Access Control User Manual Jun 2026

Connect Power Supply (GND) to Keypad GND and Lock (-). Fail-Secure Lock (e.g., Electric Strike)

A: Please follow the Initialization Procedure in Part IV. This will restore the password to 12345 .

Press * + Master Code + # (Yellow LED lights up or flashes slowly, indicating success). V2000-c Rfid Access Control User Manual

Drill the mounting holes using the supplied template. Feed the wiring harness through the wall or junction box.

The V2000-c is a standalone access control keypad that utilizes RFID card technology and a numeric keypad for secure entry. To ensure proper setup, please verify the following technical specifications: Connect Power Supply (GND) to Keypad GND and Lock (-)

| Symptom | Possible Cause | Solution | |:--------|:---------------|:---------| | No power / LEDs off | Power supply issue | Verify DC 12V and polarity | | Reader doesn't read cards | Card type mismatch | Ensure EM 125kHz card compatibility | | Buzzer continuously beeps | Anti-tamper triggered | Check cover is properly secured | | Access denied despite valid card | Access mode mismatch | Check if system requires Card+PIN | | Memory full when adding card | User capacity reached (1000 users) | Delete unused users before adding |

This section offers solutions to common issues. Press * + Master Code + # (Yellow

EM (125 kHz) or Mifare (13.56 MHz) ID cards Lock Output Load: Max 3A Alarm Output Load: Max 20A Operating Temperature: -45°C to 60°C (-49°F to 140°F) Adjustable Relay Door Time: 0–99 seconds Adjustable Alarm Time: 0–3 minutes

[Card OR PIN mode: User can enter either a registered card OR a 4-digit PIN]